Job Opportunities API

1. Mechanical Maintenance and Repair Activities Perform planned preventive, predictive, corrective, and breakdown maintenance activities on assigned mechanical equipment. Carry out daily inspections, running checks, and maintenance checklists in accordance with approved maintenance schedules. Monitor the physical condition of equipment and report abnormalities, non-conformances, and developing defects to the Mechanical Maintenance Engineer. Troubleshoot mechanical failures using approved tools, drawings, manuals, and diagnostic techniques to identify the cause and carry out necessary repairs. Perform dismantling, inspection, cleaning, repair, replacement, reassembly, alignment, and functional testing of mechanical equipment and components. Replace defective parts such as bearings, seals, gaskets, O-rings, gland packing, couplings, bolts, filters, strainers, belts, and lubrication-system components. Perform adjustment, alignment, tightening, lubrication, greasing, oil top-up, oil changing, and cleaning activities in accordance with approved procedures. Identify and report corrosion, cracks, leaks, overheating, vibration, abnormal noise, misalignment, loose bolts, damaged insulation, and other equipment defects. Ensure the working area is clean, safe, and properly restored after completion of maintenance activities. v  Support maintenance, inspection, and repair of mechanical equipment including, but not limited to: Siemens 9000HL-Class gas turbine auxiliaries, including lube oil, hydraulic oil, fuel gas, inlet air, ventilation, and turning gear systems. Steam turbine auxiliaries, including lube oil, gland steam, seal oil, condensate, cooling, and turning gear systems. Heat Recovery Steam Generator (HRSG), including drums, valves, blowdown systems, expansion joints, and associated auxiliary equipment. Pumps, including boiler feedwater pumps, condensate extraction pumps, closed cooling water pumps, service water pumps, fire water pumps, fuel oil pumps, chemical dosing pumps, and drainage pumps. Compressors, blowers, fans, air handling units, ventilation fans, and instrument/service air compressor systems. Valves, including gate, globe, check, control, safety Valves. Water treatment, reverse osmosis, condensate polishing, chemical dosing, wastewater treatment, and other balance-of-plant mechanical equipment. 2. Inspection, Testing, and Troubleshooting Conduct routine inspections and condition assessments of assigned mechanical equipment. Use approved maintenance and diagnostic tools such as vibration meters, infrared thermometers, laser alignment tools, dial gauges, feeler gauges, torque wrenches, pressure gauges, vernier calipers, and micrometers. Assist in vibration monitoring, alignment checks, bearing inspections, pump performance checks, valve testing, pressure testing, leak testing, and functional testing. Record inspection findings, test readings, equipment condition, defects identified, and maintenance work completed. Assist in identifying the root cause of equipment failures and support implementation of corrective actions. Monitor repeated failures and report recommendations for repair, modification, replacement, or maintenance-plan improvement. Support basic welding, fabrication, and workshop repair activities. Participate in planned shutdowns, major outages, overhauls, commissioning activities, warranty works, and emergency repairs.   3. Safety, Permit-to-Work, and Compliance Follow all applicable safety rules, permit-to-work requirements, lockout/tagout procedures, confined-space-entry requirements, lifting procedures, and site safety standards. Verify that equipment is properly isolated, depressurized, drained, vented, cooled down, and released for maintenance before starting work. Use required personal protective equipment, approved tools, lifting equipment, and safety devices at all times. Participate in toolbox talks, risk assessments, safety observations, haza